Skip to content

Battery chargers

Dino KRAFTPAKET 136312

A 6 V/12 V 4 A automatic charger publishing six named programmes by voltage and current, an eleven-step charge cycle, IP65 protection and a built-in battery tester.

Dino KRAFTPAKET 4 A battery charger with display

Dino KRAFTPAKET 136312

A 6 V/12 V 4 A automatic charger publishing six named programmes by voltage and current, an eleven-step charge cycle, IP65 protection and a built-in battery tester.

Programmes
Six, published individually: 7.2 V-1 A / 7.4 V-1 A / 14.4 V-1 A / 14.7 V-1 A / 14.4 V-4 A / 14.7 V-4 A (maker’s bullet)
Charge steps
Eleven, each named: measurement, desulphation, soft start, four constant-current, constant-voltage, float, analysis, maintenance (maker’s bullet)
Battery types
Lead-acid, WET, MF, GEL and AGM, 1.2–120 Ah (maker’s bullet)
Protection
Reverse-polarity proof, spark-free, IP65 jet-water protected (maker’s bullet)
Tester
Shows battery voltage; works on 12 V without mains, 6 V needs mains (maker’s bullet)
Lithium
NOT named — the chemistries listed are all lead-based.
Amazon reference
B07KSFBMXF (one reference across 5 Amazon marketplaces)
EAN
4003342177962
  • Publishes six programmes by voltage AND current — nothing else here is that specific
  • Names all eleven charge steps, so what the charger is doing is legible
  • No lithium chemistry — the list is entirely lead-based

Best for: A lead-acid, gel or AGM motorcycle battery where you want to see what the charger is doing.

≈ €30
Check price on Amazon

Specifications

Programmes
Six, published individually: 7.2 V-1 A / 7.4 V-1 A / 14.4 V-1 A / 14.7 V-1 A / 14.4 V-4 A / 14.7 V-4 A (maker’s bullet)
Charge steps
Eleven, each named: measurement, desulphation, soft start, four constant-current, constant-voltage, float, analysis, maintenance (maker’s bullet)
Battery types
Lead-acid, WET, MF, GEL and AGM, 1.2–120 Ah (maker’s bullet)
Protection
Reverse-polarity proof, spark-free, IP65 jet-water protected (maker’s bullet)
Tester
Shows battery voltage; works on 12 V without mains, 6 V needs mains (maker’s bullet)
Lithium
NOT named — the chemistries listed are all lead-based.
Amazon reference
B07KSFBMXF (one reference across 5 Amazon marketplaces)
EAN
4003342177962

What the seller commits to paper

Six programmes, each by voltage and current: 7.2 V-1 A, 7.4 V-1 A, 14.4 V-1 A, 14.7 V-1 A, 14.4 V-4 A, 14.7 V-4 A.

Eleven charge steps, each named: measurement, desulphation, soft start, four stages of constant current, constant voltage, float, analysis, maintenance.

Lead-acid, WET, MF, GEL and AGM batteries from 1.2 to 120 Ah. IP65, reverse-polarity proof, spark-free. A battery tester showing voltage, working on 12 V without mains and needing mains for 6 V. A memory function that resumes the last programme after a power cut.

This is the most legible charger on the shelf

Six programmes with their voltages and currents. Eleven steps with their names. A capacity range in amp-hours. An IP rating.

Most charger listings say “intelligent” and “fully automatic”. This one says what the intelligence consists of, in numbers, and that is what lets it be compared with anything.

The 1 A programmes matter for motorcycles

A small motorcycle or scooter battery — 6 to 12 Ah — does not want 4 A pushed into it. The 1 A programmes at both 6 V and 12 V are what make this charger suitable for one, and they are published as separate selectable programmes rather than as an automatic guess.

The chemistry not on the list

Lithium. WET, MF, GEL and AGM are all lead-based. A LiFePO4 battery is not on this list, and the NOCO charger in this family is the one that names it.

Availability

Between 30 € and 42 € across the German, French, Italian and Spanish Amazon stores, in the single reading behind this page.

An entry with nobody selling against it sits in the American Amazon catalogue.

Nothing whatever came back from the British Amazon store, so the buy button there opens a search instead of an empty page.

What Keepa returned in the single reading behind this page. Availability and prices move without notice.

Prices quoted in this text were read on 18 September 2026. The live price is at the top of the page.

More battery chargers

  • CTEK MXS 5.0 battery charger with clamps

    CTEK MXS 5.0

    A 12 V 5 A intelligent charger with a dedicated AGM programme, a RECOND mode for deeply discharged batteries, patented desulphation and temperature compensation.

    Output
    12 V, 5 A (from the title)
    AGM mode
    A dedicated charging programme for AGM batteries (maker’s bullet)
    RECOND mode
    Stated to restore batteries in poor condition or deeply discharged (maker’s bullet)
    Desulphation
    Patented, using pulsing current and voltage (maker’s bullet)
    Temperature
    Built-in automatic charging voltage compensation for extreme heat or cold (maker’s bullet)
    Lithium
    Not stated in these bullets — the NOCO charger in this family names LiFePO4 explicitly.
    Amazon reference
    DE B00DEID79G · US B06Y2FMF83 · GB B06Y2FMF83 · FR B06Y2FMF83 · IT B06Y2FMF83 · ES B06Y2FMF83
    EAN
    7340103401858
    • A five-year warranty, which is the longest published here
    • Splash- and dust-proof, short-circuit proof, with spark-free reverse-polarity protected clamps
    • No lithium chemistry named in these bullets — increasingly relevant on modern motorcycles

    Best for: A lead-acid or AGM motorcycle battery kept on charge through a winter.

    ≈ £60 / €76
    Check price on Amazon
  • Husgw 8 A battery charger with LCD display

    Husgw ZYX-J30

    An 8 A charger for 12 V and 24 V lead-acid batteries from 2 to 150 Ah, with high- and low-frequency pulse repair, an LCD display and automatic shut-off when full.

    Output
    8 A at 12 V or 24 V (from the title)
    Battery range
    12 V / 24 V lead-acid, 2 to 150 Ah (maker’s bullet)
    Repair function
    High- and low-frequency pulse technology (maker’s bullet)
    Display
    Large LCD showing charge and battery status (maker’s bullet)
    Protection
    Under-voltage, short-circuit and over-current protection; ABS housing (maker’s bullet)
    Lithium
    NOT named — lead-acid only.
    Amazon reference
    B09DTXCK9D (one reference across 6 Amazon marketplaces)
    EAN
    0794304347236
    • The only charger here that handles 24 V as well as 12 V
    • The highest current here at 8 A, which suits a larger battery
    • 8 A is more current than a small motorcycle battery wants

    Best for: A garage with a car, a van and a motorcycle, where 24 V occasionally turns up.

    ≈ €28
    Check price on Amazon
  • NOCO GENIUS5 battery charger with clamps and ring terminals

    NOCO GENIUS5

    A 5 A 6 V/12 V charger, maintainer and desulphator that names lithium LiFePO4 alongside AGM, gel and EFB, charging from 1 volt and with a manual Force mode for 0 V batteries.

    Chemistries
    Lead-acid (AGM, gel, EFB) AND lithium-ion (LiFePO4) — the only listing in this family to name lithium (maker’s bullet)
    Output
    6 V and 12 V, 5 A (from the title)
    Low-voltage start
    Charges from 1 V; a Force mode addresses deeply discharged batteries at 0 V manually (maker’s bullet)
    Temperature
    Integrated thermal sensor adjusting the charge cycle to ambient temperature (maker’s bullet)
    Repair mode
    Detects sulphation and acid stratification automatically, countering both by precise pulse charging (maker’s bullet)
    Supplied and warranty
    Charger, clamps with integrated ring terminals, instructions; 3-year warranty (maker’s bullet)
    Amazon reference
    DE B0828KQKBM · GB B0828KQKBM · FR B083RJZ7VK · IT B0828KQKBM · ES B08435NK3X
    EAN
    0046221190267
    • The only charger here that names LiFePO4 — the chemistry arriving on modern motorcycles
    • Charges from 1 V, with a manual mode for a battery reading zero
    • Not found on the US market, and the ASIN differs between several markets

    Best for: Any motorcycle, and the only obvious choice here if the battery is lithium.

    ≈ €68
    Check price on Amazon

The rest of this rider’s shelf

  • Liqui Moly DOT 4 brake fluid 500 ml bottle

    Liqui Moly DOT 4, 500 ml

    A 500 ml DOT 4 brake fluid published to three standards with a viscosity figure of 1800 mm²/s, stated miscible with high-quality synthetic brake fluids.

    Viscosity
    1800 mm²/s (from the title)
    Specifications
    FMVSS 116 DOT 3 / 116 DOT 4 | ISO 4925 Class 3 / Class 4 | SAE J 1703 / J 1704 (maker’s bullet)
    Volume
    500 ml (from the title)
    Miscibility
    Miscible and compatible with high-quality synthetic brake fluids (maker’s bullet)
    Low temperature
    Stated excellent low-temperature behaviour (maker’s bullet)
    Boiling points
    Stated extremely high wet and dry — no figure is given (maker’s bullet)
    Amazon reference
    B07L4T6LPF (one reference across 6 Amazon marketplaces)
    EAN
    4100420211560
    • Publishes a viscosity figure, which no other fluid in this family does
    • Three standards including the ISO class
    • Boiling points described rather than given, where one rival publishes ≥ 230 °C

    Best for: One brake bleed, on a machine that sees cold mornings.

    ≈ €7
    Check price on Amazon
  • Liqui Moly SL6 DOT 4 brake fluid five-litre container

    Liqui Moly SL6 DOT 4, 5 L

    A five-litre DOT 4 brake fluid published against FMVSS 116, ISO 4925 Class 6 and SAE J 1703/J 1704, with car manufacturer recommendations listed.

    Specifications
    FMVSS 116 DOT 3 / 116 DOT 4 | ISO 4925 Class 6 | SAE J 1703 / J 1704 (maker’s bullet)
    Class
    ISO 4925 Class 6 — higher than the Class 3/4 published by the other fluids in this family
    Volume
    5 litres (from the title)
    Stated recommendations
    Audi, BMW, GM Europe, Seat, Skoda and VW approvals — all car manufacturers (maker’s bullet)
    Boiling points
    Stated extremely high wet and dry boiling points — no figure is given (maker’s bullet)
    Miscibility
    Miscible and compatible with high-quality synthetic brake fluids (maker’s bullet)
    Amazon reference
    B07N94TH1L (one reference across 5 Amazon marketplaces)
    EAN
    4100420211690
    • Publishes three standards and an ISO class above everything else here
    • States miscibility with other synthetic fluids explicitly
    • Wet and dry boiling points are described as extremely high and never given as numbers

    Best for: A full brake and clutch bleed where the machine’s manual permits a Class 6 DOT 4.

    ≈ €49
    Check price on Amazon
  • MANNOL 3002 DOT-4 brake fluid five-litre container

    MANNOL 3002 DOT-4, 5 L

    A five-litre DOT-4 hydraulic fluid published to SAE J1703/J1704, ISO 4925 Class 3/4 and FMVSS 116 DOT 3/4, stated for conventional brake and clutch systems.

    Specifications
    SAE J1703/J1704, ISO 4925 Class 3/4, FMVSS 116 DOT 3/4 (maker’s bullet)
    Stated use
    All conventional hydraulic BRAKE AND CLUTCH systems (maker’s bullet)
    Volume
    5 litres (from the title)
    Viscosity
    Stated excellent viscosity-temperature behaviour — no figure given (maker’s bullet)
    Protection
    Stated to prevent vapour lock and protect against corrosion and oxidation (maker’s bullet)
    Boiling points
    The maker puts nothing in writing on this.
    Amazon reference
    B00GHXBIJG (one reference across 4 Amazon marketplaces)
    EAN
    4036021889429
    • Three standards published, including the ISO class
    • Names hydraulic CLUTCH systems explicitly, which many motorcycles have
    • No boiling point published

    Best for: A machine with a hydraulic clutch as well as hydraulic brakes, both bled at once.

    ≈ €33
    Check price on Amazon

All battery chargers